Nidac VST62 - Page 34

31
Add a Primary User Code for Auxiliary Lock Control
  <code>     
Add a Manager Code for Lock Control
  <code>   
Delete a code
  <code> 
Delete all User Codes
Use            to delete all programmed user
codes (including manager codes). The default manager and test codes
are enabled until new codes are programmed.
Exit Manager Mode
To exit manager mode press   
The keypad will respond with a Warble on a successful addition or
deletion of a code and with a Long Beep when unsuccessful.
In the Manager mode the Status LED indicates the conditions below.

-
Waiting for the start of a programming or exit sequence.

Green
- Adding a code, waiting for <user location> or  to be entered.

Green
-
Adding a code, waiting for the new <code> to be entered.

Green
Red
-
Adding a code (

<user location> already entered) to a user
location with an existing code in it. Waiting for new <code> to
be entered to overwrite the existing one.

Orange
-
Adding a code, waiting for the user level digit (,  or ) or 
to be entered.

Orange
-
Adding a code, waiting for the lock output control digit (

,

or

) or

to be entered.

Red
-
Deleting a code or exiting manager mode, waiting for <user
location>,

or

to be entered.

Red
-
Deleting a code by search method (
 
already entered),
waiting for the existing user code to be entered.