Nikon D5000 - Page 118

100
t
When the camera is ready to measure white
balance, a flashing D (L) will appear in
the viewfinder and information display.
5 Measure white balance.
Before the indicators stop flashing, frame the
reference object so that it fills the viewfinder
and press the shutter-release button all the
way down.
No photograph will be recorded; white balance can be measured
accurately even when the camera is not in focus.
6 Check the results.
If the camera was able to measure a value for
white balance, the message shown at right
will be displayed and a will flash in the
viewfinder for about eight seconds before
the camera returns to shooting mode.
To
return to shooting mode immediately, press
the shutter-release button halfway.
If lighting is too dark or too bright, the
camera may be unable to measure white
balance.
A message will appear in the
information display and a flashing ba
will appear in the viewfinder.
Press the
shutter-release button halfway to return to
Step 4 and measure white balance again.