Chapter 8 Troubleshooting
3 Electrical
43
8
3
Electrical
Lamp does not light when switched on.
Causes Corrective Measures
No electrical power.
Insert the power cord into an electrical
outlet. (P.29)
Power cord is not connected to the
microscope main body.
Insert the power cord into the AC inlet.
(P.29)
Lamp is not installed.
(for E200 MV series only)
Install correctly. (P.32)
Lamp is burnt out.
(for E200 MV series only)
Replace lamp. (P.32)
Incorrect lamp is used.
(for E200 MV series only)
Use the specified lamp. (P.32)
Flickering or unstable lamp brightness.
Causes Corrective Measures
Lamp is about to burn out.
(for E200 MV series only)
Replace lamp. (P.32)
Power cord is not correctly connected.
Connect correctly.
Lamp is not correctly inserted into
socket. (for E200 MV series only)
Insert correctly. (P.32)
Sudden lamp failure.
Causes Corrective Measures
Incorrect lamp is used.
(for E200 MV series only)
Use the specified lamp. (P.32)
To Next Page
Loading...
