53
Operation
3
Warning
• Before using the product, thoroughly read the “Safety Precautions” at the beginning of this
manual, and heed all warnings and cautions written therein.
• To use other equipment such as epi-fl attachment or differential interference contrast
attachment, refer to the respective manuals and heed all warnings and cautions written
therein.
Caution
When using the PFS Motorized Nosepiece, use the “Ti Control” setup software for Ti series to
register the objective information from a PC. PFS Motorized Nosepiece will not function
properly unless the objective information has been registered correctly. For details on using
“Ti Control”, refer to the “Ti Control” instruction manual.
This chapter describes the operation methods for each part of the product.
• For the name and position of each part, refer to Chapter 1, “Part Names.”
• For the microscopy procedure, refer to Chapter 2, “Microscopy.”
• If the microscope has not been assembled yet, first refer to Chapter 4, “Assembly.”
• If your microscope system has the epi-fl attachment or the differential interference contrast attachment,
refer to the respective instruction manuals.
• If your microscope system is equipped with the TI-HUBC/A Hub Controller A, refer to the instruction
manual provided with the hub controller.
To Next Page
Loading...
