26
(800) BUY-HIFI NILES AUDIO CORPORATION
INSERTING THE BATTERY
The iRemote uses a nickel metal hydride rechargeable
battery that must be fully charged prior to initial use.
Install the battery and allow it to charge for 12 hours,
before initial use.
CHARGING THE IREMOTE
Your new iRemote comes equipped with a recharge-
able battery, charging base and power supply. After
every use, place your iRemote into the charging base
cradle. The charging base’s front panel light changes
from light blue to bright blue when the remote is seated
correctly. When the battery is charging, the LCD dis-
play reads “Charging”, and when charging is complete
the display reads “Charging Complete.” The iRemote
operates approximately 8 hours in normal mode or 24
hours in battery save mode.
INSTALLING AND CHARGING
THE iREMOTE
®
BATTERY
GETTING STARTED
DISPLAY SETTINGS (BATTERY SAVE)
System (CAT-5) connects to IntelliControl ICS Modular MultiZone
Receiver Communication & Control Switch when used as Master
Charging Base
Power Jack
12V DC
Power Supply
Press the Niles System Settings
Key. The “System Settings menu”
appears.
Press the [Page
] Soft Key to move
to the second screen of settings.
Highlight [Display Settings] and
press the SELECT
Key to proceed.
Press the Cursor
Key to move
from [Backlight On] time to [Bat-
tery Save].
Use the Cursor
or Key to set the
length of time until the iREMOTE goes into
deep sleep mode.
Back
Display Settings
Contrast 65%
Backlight on: 30 sec.
Battery save
after 5 minutes
System Settings
BackPage Page
Turn On Volume
Display Settings
NOTE: Battery Save mode disconnects the iREMOTE from the GXR2
network and doesn’t display metadata until picked up.
To Next Page
Loading...
Need help?
General