Scub Sytem - Disc 42Service Manual – SC351
Maintenance and Adjustments
Brush Cleaning
Warning! It is advisable to wear protective gloves when cleaning the brush because there may
be sharp debris.
1. Remove the brush.
2. Clean the brush with water and detergent.
3. Check the brush bristles for integrity and wear; if necessary, replace the brush.
Machine Speed Adjustment
Note: Themachinespeedandforwardmovementvaryaccordingtothetypeofoortobe
cleaned and the choice of using the brush or the pad.
If necessary, perform the adjustments as shown.
1. Remove the recovery and the detergent tanks.
2. Adjust the machine speed with the handwheel (A):
◦ Turn the handwheel counter-clockwise to increase the machine speed.
◦ Turn the handwheel clockwise to decrease the machine speed.
3. If it is difcult to keep the machine moving in a straight line because it deviates to the left or to the
right, adjust the handwheel (B) by turning it clockwise or counter-clockwise.
4. After adjusting, install the tanks.
5. With the machine ready to operate, perform hands-on tests of the machine and, if other adjustments are
necessary, repeat steps 1 to 4.
A
B
P100795
To Next Page
Loading...
Need help?
General
