13Service Manual – SC401, SCRUBTEC 344 03 - General Information
− In case of re, use a powder re extinguisher, not a water one.
− Do not tamper with the machine safety guards and follow the ordinary maintenance
instructions scrupulously.
− Do not allow any object to enter into the openings. Do not use the machine if the
openings are clogged. Always keep the openings free from dust, hairs and any other
foreign material which could reduce the air ow.
− Do not remove or modify the plates axed to the machine.
− This machine cannot be used on roads or public streets.
− Pay attention during machine transportation when temperature is below freezing point.
The water in the recovery tank or in the hoses could freeze and seriously damage the
machine.
− Use only the brushes supplied with the machine or those specied in the Instructions
for Use Manual. Using other brushes could reduce safety.
− In case of machine malfunctions, ensure that these are not due to lack of maintenance.
If necessary, request assistance from the authorised personnel or from an authorised
Service Center.
− If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or
Retailer.
− To ensure machine proper and safe operation, the scheduled maintenance shown in
the relevant chapter of this Manual, must be performed by the authorised personnel or
by an authorised Service Center.
− Do not wash the machine with direct or pressurised water jets, or with corrosive
substances.
− The machine must be disposed of properly, because of the presence of toxic-harmful
materials (batteries, etc.), which are subject to standards that require disposal in
special centres.
To Next Page
Loading...
