USER MANUAL ENGLISH
33019216 - SR 1601 D3 / LPG3 / P3 7
WARNING!
– (Only for versions equipped with dust guard system) Pay attention during machine transport when
temperature is below freezing point. The water in the system tank or hoses could freeze and seriously
damage the machine.
– Do not remove or modify the plates afxed to the machine.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary, request
assistance from the authorised personnel or from an authorised Service Center.
– If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
this Manual, must be performed by the authorised personnel or by an authorised Service Center.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
oils, plastics, etc.), which are subject to standards that require disposal in special centres (see the Scrapping
chapter).
– While the engine is running, the silencer warms up; do not touch the silencer when it is hot to avoid burns or
res.
– Running the engine with an insufcient quantity of oil can seriously damage the engine. Check the oil level
with the engine off and the machine on a level surface.
– Never run the engine if the air lter is not installed, because the engine could be damaged.
– Technical service procedures on the engine must be performed by an authorised Dealer.
– Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality
can seriously damage the engine.
– See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of this Manual.
Guide lines to bacteria control and other dangers coming from the presence of microbes in the dust guard system.
WARNING!
To prevent the operators and other people from developing infections caused by microbes and Legionella that
may ourish in the dust guard system, take the following precautions:
– If possible, ll the tank with cold water (< 20°C).
– DO NOT use stagnant water to ll the tank.
– DO NOT use recycled water, undrinkable water or water that has been in contact with the soil.
– Adjust and turn the nozzles towards the oor only, from preventing possible inhaling.
– Do not store the machine outdoors or near sources of heat.
– Do not over-ll the tank. Fill the tank sufciently so that it can be emptied by using the system.
– Empty the tank every 10 hours or once a week, according to the use.
– If the machine is not used for more than one week, empty the tank completely, and let it dry.
– If the tank cannot be cleaned regularly, consider using a biocide that can kill or exert a controlling effect on
Legionella bacteria. Biocide must be chosen according to the local regulations and must be used according
to the relevant instructions and cautions, to avoid that the personnel gets affected by dangerous chemical
substances.
– If chemical products have to be used in the water tank, it is mandatory to apply the relevant information and
caution labels of the product.
33019216(4)2012-03 A.indb 7 10/04/2012 15:52:44
To Next Page
Loading...
Need help?
General
