ENGLISH USER MANUAL
2 SCRUBTEC 233 9097883000(1)2008-06 A
INTRODUCTION
NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
Thank you for choosing a Nilfi sk Alto scrubber-dryer.
Nilfi sk Alto Scrubtec 233 scrubber-dryer is an effi cient and superior quality machine for fl oor cleaning.
The machine is equipped with two turning brushes for a cleaning width of 330 mm.
Front and rear squeegees clean out the fl oor, while a vacuum system collects the dirty water, all in one wipe.
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualifi ed technicians must read this Manual carefully. Contact
Nilfi sk Alto in case of doubts concerning the interpretation of the instructions and for any further information.
TARGET
This Manual is intended for operators and technicians qualifi ed to perform the machine maintenance.
The operators must not perform procedures reserved for qualifi ed technicians. Nilfi sk Alto will not be answerable for damages
coming from the non-observance of this prohibition.
HOW TO KEEP THIS MANUAL
The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can cause
damage to it.
DECLARATION OF CONFORMITY
The Declaration of Conformity, supplied with the machine, certifi es the machine conformity with the law in force.
NOTE
Two copies of the original declaration of conformity are provided together with the machine documentation.
IDENTIFICATION DATA
The machine model and serial number are marked on the plate (1).
The machine production year is written in the declaration of conformity and it is also indicated by the fi rst two fi gures of the machine
serial number.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identifi cation data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................
To Next Page
Loading...
Need help?
General
