EasyManuals Logo

Nilfisk-ALTO Scrubtec 233 User Manual

Nilfisk-ALTO Scrubtec 233
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
ENGLISH USER MANUAL
12 SCRUBTEC 233 9097883000(1)2008-06 A
MACHINE TRANSPORT/PARKING
To transport/park the machine, proceed as follows.
Turn off the machine by pressing the switch (6).1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7).2.
Push the machine with the handlebar (2) and keep the brush/squeegee-holder deck slightly lifted.3.
Lift the machine and turn the parking lever (24, if equipped) to position (24b).4.
TANK EMPTYING
WARNING!
To avoid spilling the water (for example during an abrupt machine manoeuvre), drain the recovery tank (16) at
the end of every cleaning cycle.
Use the transparent cover with vacuum grid (15) to check if the recovery tank (16) is full.
CAUTION!
If the recovery tank (16) is not emptied when full, the vacuum system ejects the excess of liquid through the air
outlets, thus dampening the oor.
When the recovery tank (16) is full, empty it according to the following procedure.
Recovery tank and solution tank emptying
Turn off the machine by pressing the switch (6).1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7).2.
Drive the machine to the appointed disposal area.3.
Lift the brush/squeegee-holder deck and turn the parking lever to position (24b).4.
Carefully remove the quick coupling (28) from the solution tank.5.
Move the transparent cover (15) aside and lift the tanks with the handle (26).6.
Open the recovery tank drain plug (19) and empty the tank.7.
If necessary empty the solution tank (14) by opening the plug (18).8.
Then, rinse the tanks and the solution hose lter (25) with clean water.9.
AFTER MACHINE USE
24b
7
10
14
16
24
P100310
After working, before leaving the machine:
Turn the parking lever (24, if equipped) to position (24b).1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7).2.
Empty the tanks (14 and 16) as shown in the previous paragraph.3.
Perform the daily maintenance procedures (see the Maintenance chapter).4.
Store the machine in a clean and dry place.5.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-ALTO Scrubtec 233 and is the answer not in the manual?

Nilfisk-ALTO Scrubtec 233 Specifications

General IconGeneral
BrandNilfisk-ALTO
ModelScrubtec 233
CategoryFloor Machine
LanguageEnglish

Related product manuals