USER MANUAL
ENGLISH
9097883000(1)2008-06 A SCRUBTEC 233 11
MACHINE START AND STOP
1
55a
5c5d
5b 6
3
16
15
2
7
26
18
14
24
24a 24b
4
11
25
19
15
17
28
10
P100309
Starting the machine
Prepare the machine as shown in the previous paragraph.1.
Turn the parking lever (24, if equipped) to position (24a).2.
Drive the machine to the working place by pushing it with the hands on the handlebar (2).3.
Connect the power supply cable (10) to the electrical mains.4.
WARNING!
Before connecting the power supply cable to the electrical mains, check that frequency and voltage, shown on
the machine serial number plate (1), match the electrical mains voltage.
Turn the knob (5) to the suitable program.5.
Brushes - vacuum system - solution fl ow activation• (5a)
Brushes - solution fl ow activation• (5b)
Vacuum system activation• (5c)
Fitted carpet cleaning and fl oor wiping (optional)• (5d)
Turn on the machine by pressing the switch (6) and start cleaning the fl oor.6.
Stopping the machine
Turn off the machine by pressing the switch (6).7.
Disconnect the power supply cable (10) from the electrical mains.8.
Lift the brush/pad-holder by turning the transport/parking device (24, if equipped) to position (24b).9.
MACHINE OPERATION (SCRUBBING/DRYING)
Start the machine as shown in the previous paragraph.1.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the fl oor.2.
CAUTION!
To avoid damaging the fl oor surface, do not use the brushes without the solution and, when the machine is not
operating, stop the brush/pad-holder by pressing the program (5c or 5d), or by pressing the switch (6).
CAUTION!
Before lifting the brush/pad, turn it off by pressing the switch (6).
To Next Page
Loading...
Need help?
General
