USER MANUAL
ENGLISH
9097883000(1)2008-06 A SCRUBTEC 233 13
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Machine Use paragraph.1.
Store the machine in a clean and dry place.2.
FIRST PERIOD OF USE
After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the power supply cable
disconnected from the electrical mains.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Brush cleaning
Squeegee cleaning
Tank and vacuum grid cleaning
Squeegee blade check and replacement
Solution hose fi lter cleaning
Screw and nut tightening check (1)
Vacuum system motor carbon brush check and replacement (2)
And after the fi rst 8 working hours.(1)
This maintenance procedure must be performed by Nilfi sk Alto authorised Service Center.(2)
To Next Page
Loading...
Need help?
General
