Use and maintenance
47
3. Open the box and take out the copy of
the instruction manual which is on top
of the polyurethane protection;
4. Continue as indicated in the manual;
5. Push the upper cardboard box down
(1) using the flaps so that the next step
is easier, that is removing the
polyurethane protection and the corner
reinforcements (2);
6. Remove the above mentioned
protection and the corner
reinforcements;
7. Lift and take out the machine which is
wrapped in a sheet of transparent
polyethylene;
ATTENTION: The machine must be lifted by
two people, taking into account that it weighs
more on the side where the blade is.
8. Once this operation is over, check the contents of the box and make sure it corresponds to
the label on the outside.
WARNING: The packaging components (plastic straps, cardboard, polyurethane foam) can
be thrown away with normal solid wastes and therefore there is no difficulty in disposing of
them.
However it is advisable to dispose of products separately (differential collecting) in
conformity with the regulations in force for adequate recycling.
DO NOT DISCARD THE PACKAGING PRODUCTS IN THE ENVIRONMENT!
To Next Page
Loading...