Noaw TWS - Troubleshooting and Failure Resolution; Common Problems and Solutions

Use and maintenance
65
8. LOCATING AND ELIMINATING FAILURES
WARNING: In this chapter the most common problems caused while using the slicing
machine are listed together with the necessary operations to eliminate the possible
causes.
If the problem persists ask for assistance from a qualified person authorized by the
manufacturer, do not insist on looking for the cause.
PROBLEM
PROBABLE CAUSE
CURE
Pressing the start button the
machine does not start.
No electricity.
Check that the plug is
correctly inserted.
Pressing the start button the
machine starts but the
working light does not come
on.
Light is defective.
Do not use the machine if the
light does not work. Contact
service for assistance.
The machine starts but the
motor heats up too much, it
gives off a bad odour.
Defective motor.
Do not use the machine.
Contact service for
assistance.
The machine vibrates.
Defective transmission.
Contact service for
assistance.
Excessive resistance in
cutting the product.
The blade is not sharp.
Sharpen the blade.
The blade slows or stops
under stress.
Loose belt.
Contact service for
assistance.
Sharpening is no longer
regular.
Grindstones are excessively
dirty.
Clean the grindstone.
Grindstones worn out.
Replace the grindstones.
Contact service for
assistance.
The sliced product is frayed
and irregular.
The blade is not sharp.
Sharpen the blade.
The blade is excessively used
Replace the blade. Contact
service for assistance.
The machine does not stop
when the stop button is
pressed.
Control circuit is defective.
Pull out the plug to stop the
machine and immediately
contact service for assistance.