Use and maintenance
71
Any improper use of the machine releases the manufacturer from any responsibility for
accidents to persons or situations and invalidate the warranty provided.
Before connecting, verify that the electric supply mains is suitable for the machine by
checking the technical data plate on the machine
Do not use the machine with electrical connections of a “temporary” nature.
You must load the products when the machines is turned off in order to avoid hits that could
damage the blade!
Before cleaning or carrying out any maintenance, disconnect the machine from the electric
mains supply.
Do not use abrasive, acids products or brushes that could damage the machine. Do not
clean the slicer with water or stream jets or similar methods.
Do not put the removed parts in the dishwasher.
WARNING: The blade can be sharpened up until the distance between the cutting edge of the
blade and the inside border of the blade guard ring is no more than 6 mm., corresponding to
a decrease of about 10 mm. of the size of the original diameter. Once this value has been
reached, it is NECESSARY TO REPLACE THE BLADE and this operation must be carried out
EXCLUSIVELY by personnel authorized to by the manufacturer.
Only use white vaseline oil.
DO NOT USE VEGETABLE OILS!
To Previous Page
Loading...