8
INSTRUCTIONS
INSTALLATION
THERMOSTATS:
The thermostats on your NOBLE UH/UL30 unit have been set at the factory. They
should only be adjusted by an authorized service agent.
This equipment is not recommended for use with deionized water or other aggressive
uids. Use of deionized water or other aggressive uids will result or corrosion and
failure of materials and components. Use of deionized water or other aggressive uids
will void the manufacturers warranty.
NOTE: The bottom of the chemical container cannot be located any higher than 8”
from the oor. If the unit is equipped with the 6” or 18” table stand, then the highest
position will respectively be 14” or 26” from the oor. this, contact Noble immediately
for assistance.
It is important to remember that if you decide to operate the unit in chemical sanitizing
mode, you must ensure an appropriate chlorine-based sanitizer is used in the nal
rinse line.
WARNING! CHLORINE BASED SANITIZERS CAN BE DETRIMENTAL TO YOUR
MACHINE IF THE CHEMICAL SOLUTION IS TOO STRONG. SEE YOUR CHEMICAL
PROFESSIONAL TO ENSURE YOUR DISPENSER IS SET UP CORRECTLY.
The NOBLE UH30 dish machine is supplied with integral detergent and rinse aid
chemical feeder pumps. The NOBLE UL30 dish machine is supplied with integral
detergent, rinse additive, and sanitizer chemical feeder pumps. Locate the open ends
of the chemical tubes with the tube stiffeners and place each one in the appropriate
container.
A. Red Tubing=Detergent
B. Blue Tubing= Rinse Aid
C. White Tubing= Sanitizer
Chemical feeder pumps need priming when the machine is rst installed or if for some
reason, the chemical lines have been removed and air is allowed to enter.
CAUTION! Water must be in the sump and wash tank prior to the dispensing of
chemicals. Sanitizer in concentration is caustic and may cause damage without
dilution.
CHEMICAL FEEDER
EQUIPMENT:
TO PREPARE
CHEMICAL
FEEDER PUMPS
FOR OPERATION:
PRIMING CHEMICAL
FEEDER PUMPS:
To Next Page
Loading...
