9
PRIMING CHEMICAL
FEEDER PUMPS
(CONTINUED):
INSTRUCTIONS
INSTALLATION
1. Verify that the proper chemical tube stiffener inlet is in the proper container.
2. Use the prime switches located on the control panel at the bottom of the unit to
prime each pump. The switches are clearly marked as to what chemical feeder
pump they are assigned to.
3. To prime the pumps, hold the switch in the momentary position until chemical
can be observed entering the pump.
4. Detergent is dispensed as required during the wash cycle by the timer. The
amount of detergent may need to be increased or decreased depending upon
water quality and type of detergent.
5. Rinse additive is dispensed as required into the nal rinse. The amount of rinse
additive may need to be adjusted depending upon water hardness & results.
6. Sanitizer (either chlorine or iodine) is dispensed into the nal rinse. The amount
of sanitizer may need to be adjusted depending on the concentration and type
of sanitizer used.
7. Please refer to the next page for instruction on adjusting the chemical feeder
pumps on the universal timer.
WARNING: Some of the chemicals used in dish washing may cause chemical
burns if they come in contact with your skin. Wear protective gear when han-
dling these chemicals. If you do come in contact with these chemicals, imme-
diately follow the instructions provided with the chemicals for treatment.
To Next Page
Loading...
