10
Extend the antenna fully.
As with any other radio transmitting device, avoid
prolonged contact with the antenna when the phone is
switched on.
1) Press the PWR key and hold it for at least 2 seconds.
The phone will carry out a short self-test sequence, then
briefly display its programmed name or number.
2) When the ON indicator appears on the display, the
phone is ready for use.
If NO SVC appears it likely means that you are outside the
cellular service area and the network cannot serve you.
A cellular phone can only send and receive calls
when it is switched on.
3) Press the PWR key and hold it for at least 2 seconds to
switch the phone off.
Fully extend the antenna before
sending or receiving a call.
Note: Push in the antenna when
you are not using the phone.
You can use the phone without
extending the antenna in a
good coverage area (see
‘Signal Strength’).
1) Key in the number (include
the area code, if you’re making
a long distance call).
If you make a mistake, press the CLR key to delete the last
keystroke; or to clear the whole display, press and hold the
CLR key.
2) The number will appear on the display.
3) Press SEND.
PLACING A CALL
SWITCHING ON (OR OFF)
OPERATION OF THE PHONE
To Next Page
Loading...
Need help?
General
Weight and Dimensions
