16
If you do not want to delete the existing information, either
press CLR or wait until the message STORE NOT DONE
appears on the display. The information you tried to store
will then reappear on the display, and you can store it in a
different memory location as described above.
10) If you attempt to store a name
that has previously been stored,
the display will read ‘REPLACE
NAME?’.
Note: You may also begin the
memory store procedure in the ALPHA mode, followed by
the phone number.
1) Press ALPHA. The ALPHA indicator will appear on the
display to show that the phone is in the alpha mode. When
you press a key, letters will appear instead of numbers.
2) Select the key labeled with the letter you want. Press it
once to obtain the first letter, twice (before the ALPHA
indicator flashes) to obtain the second, and three times
(before the ALPHA indicator flashes) to obtain the third.
If you miss the letter you want, continue pressing until it is
displayed again.
3) Select further letters in the same way.
4) If you want the same letter twice, either select it as above,
wait until the ALPHA indicator flashes once and select it
again; or select the letter, press
*
, then select it again.
5) Note that in ALPHA mode the 0 key provides a space,
and the 1 key provides a ‘-’ (hyphen).
6) Note that you can enter up to 16 characters (8 per each
line of the display). Each “space” and “hyphen” entry is
included as part of the maximum 16 characters.
7) If you begin your memory store procedure in ALPHA
mode when you have finished keying in the name, exit
ALPHA mode by pressing ALPHA again. Now you can
key in numbers.
KEYING IN NAMES
To Next Page
Loading...
Need help?
General
Weight and Dimensions
