11
4) The IN USE indicator will appear, and the number will
disappear from the display.
5) Lift the phone to your ear, and wait until your call is
answered.
6) When you have finished the call, press END.
If the message NO SERVICE appears, you are outside the
cellular service area.
If the message LOCKED appears on the display when you
try to make a call, your phone has been electronically
LOCKED see (‘Locking the Phone’). You can still make
emergency calls and calls to the number in memory
location 48, when the phone is locked.
1) When there is an incoming call, the phone rings and the
CALL message flashes on the display.
If the ringing tone has been switched off – the SILENT
SERVICE feature has been selected for privacy or other
reasons – the keypad and display lights will flash instead
and only one short
“beep”
will be given. (see ‘Setting the
Ringing Volume’).
2) Press SEND and lift the phone to your ear.
(For your comfort do not lift the phone to your ear before
pressing SEND.)
3) When you have finished speaking, press END.
If you don’t answer the call, the CALL message will remain
on the display (showing that someone has tried to phone
you). Press any key to clear the display.
The quality of your call depends on the strength of the
cellular signal in your area. The phone displays current
signal strength as a series of bars on the left side of the
display screen. The more bars, the better the signal. If the
signal is poor, try moving the phone slightly to improve
reception. If you are using the phone in a building, it may
be necessary to move near a window, or outdoors for
better reception.
SIGNAL STRENGTH
RECEIVING A CALL
To Next Page
Loading...
Need help?
General
Weight and Dimensions
