18
3) The telephone number stored in
that memory location will appear
on the display.
If the memory location is empty,
the message EMPTY will appear.
4) If you want to check the name stored against the
number, press ALPHA. (If a name was not stored with the
number, the display will be blank). Press ALPHA again to
return to the number display.
5) Call the number by pressing SEND. (You can place
your call with either the number or the name displayed).
1) Press ALPHA.
2) Key in the name you want to recall (see ‘Keying in
Names’).
3) Press RCL.
4) The name, and the location number of the memory it is
stored in, will appear on the display.
5) If you want to check the phone number, press ALPHA
again.
6) Call the number by pressing SEND. (You can place
your call with either the name or the number displayed).
7) Note that if you enter a name
that does not exist in the memory,
the display will read ‘NOT FOUND’.
1) To scan the entire memory, press RCL and v to display
the contents of the first memory location. Use v or V to
display the next or previous memory location.
If you recall a memory location by number, (eg. RCL,0,2),
you can start scanning from that memory location.
2) When you find the number you want, press SEND to
make the call.
SCANNING FOR A NUMBER
To Next Page
Loading...
