Move the pointer with or to either option and
press the
OK
selection key.
The phone number and the delay time will remain on
the display for a while so that you can check and write
them down.
You can modify the phone number in this menu or by
using a manual command string. The delay time can be
modified by a manual command string only (see the
note below).
The activated divert mode and the specified phone number
(and with the mode
DIVERT WHEN NOT ANSWERED
, the
delay time) will apply to voice calls and all other call types. If
you want to activate some other mode and set a different
phone number (and delay time) for a single call type, you
need to use manual command strings (see the note below).
When you make a call and a divert mode is selected (except
for
CANCEL ALL DIVERTS
), the phone will display a text re-
minding you that your incoming calls will be diverted to an-
other phone number. The text will appear only if your network
operator supports this feature.
Note:
Instead of using this menu function, you may set on
and off different divert modes by using manual command
strings.
In idle mode, key in a command string and press the
key to transmit it to the network. For required command
strings, contact your network operator.
Menu Functions
66
To Next Page
Loading...
Need help?
General
