Erase
Removes the message from the display and from the
memory. No message will be shown when the phone is
switched on next time.
➎
Press the
OK
selection key to perform the desired
operation.
Next time you switch the phone on, the stored message will
pop up on the display. Once you have read the message,
you can either remove it by pressing the
Erase
selection
key or keep it by pressing the
Keep
selection key or the
C
key.
With the message on the display, you may press a number
key and then perform any memory or menu operation in the
normal way, e.g. make or receive a call. When you delete all
characters from the display (by pressing and holding the
C
key), the message will be shown again.
COUNTDOWN TIMER (Menu 9 2)
The phone can be programmed to alarm after a specified
period of time.
The time will stay in effect only as long as the phone remains
switched on. When the phone is switched off or the battery
runs out of power, the clock is reset and you have to re-pro-
gram it.
➊
Press
Menu
9 2
to enter this function.
➋
At the prompt
Set timer:
, key in the time after which the
alarm will be issued. For example,
02h 30min
sets the
phone to alarm after 2 hours and 30 minutes.
➌
Press the
OK
selection key.
Once the given time expires, the phone will play a repeating
ringing tone and the message
COUNTDOWN TIME UP
will
Menu Functions
91
To Next Page
Loading...
Need help?
General
