FMTx 2.1 schematic
Figure 52 FMTx 2.1 schematic
The handset uses an antenna that is integral to the removable cover. The connection to the cover is exposed
when the cover is removed.
The loop antenna requires two connection points, J6200 and J6201 (the signal and the ground). It is important
to check these connection points for damage or dirt since the performance of the FMTx 2.1 implementation
will be severely impaired if these connections are not in good condition.
FMTx 2.1 component layout
Figure 53 FMTx 2.1 component references and location
The main component of the FMTx 2.1 solution is the Si4713 low power transmitter device (N6150).
RM-484; RM-485; RM-486
FMTx 2.1 Troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 7 –5
Copyright © 2009 Nokia. All rights reserved.
To Next Page
Loading...
