ACCESS GATEWAY
52 Configuring the Wireless Connect Gateway
Item Default Description
RADIUS
Authentication
Disable Option: No Authentication or RADIUS Server.
Disable (No Authentication) ―
Subscriber can have direct access the Internet
without enter username and password.
Enable (RADIUS Authentication) ―
Wireless Connect Gateway provides “RADIUS
Authentication” for service provider to build up an
Internet service with RADIUS server. If RADIUS
Authentication is enabled, all Subscribers’
authentication will be sent to the RADIUS Server by
RADIUS protocol (RFC 2865, 2866).
Time to Finish/
Accumulation
Enable Service provider provides two different accounting
calculations for the Internet service.
Primary RADIUS Server
Server IP Empty Enter the IP address of RADIUS server.
Authentication Port 1812 Enter the authentication port number; the
authentication port number must match with the
RADIUS server setting. The allowed numbers are
from 0 to 65535.
Accounting Port 1813 Enter the accounting port number; the accounting
port number must match with the RADIUS server
setting. The allowed numbers are from 0 to 65535.
Share Secret Key Empty The share secret key, the key number also has to
match with the Server setting. Up to 64 characters
are allowed.
Secondary RADIUS Server
Server IP Empty Enter the IP address of RADIUS server.
Authentication Port 1812 Enter the authentication port number; the
authentication port number must match with the
secondary RADIUS server setting. The allowed
numbers are from 0 to 65535.
Accounting Port 1813 Enter the accounting port number; the accounting
port number must match with the secondary RADIUS
server setting. The allowed numbers are from 0 to
65535.
To Next Page
Loading...
