Nomadix NWCG - Getting Started

ACCESS GATEWAY
16 Installation
 Your PC’s default gateway IP address
 Your PC’s primary DNS IP address
Note: The gateway’s default IP address setting is “10.59.1.1”. The gateway’s default subnet mask
setting is “255.0.0.0”.
The Dynamic IP settings for the PC
We recommend that you leave your IP settings as automatically assigned. By default, the
Wireless Connect Gateway is a DHCP server, and it will give your PC the necessary IP
settings.
Getting Started
1. Place the Wireless Connect Gateway and VP 20 Printer on a flat work surface.
2. Connect the Ethernet cable to the Wireless Connect Gateway’s Eth port.
3. Connect the other end of the Ethernet cable to the VP 20 Account Generator Printer’s
RJ45 port.
4. Ensure that your modem and computer are both switched on.
5. Use the supplied cable to connect the Wireless Connect Gateway's WAN port to the
modem. Check that the modem or router Status LED lights show a link present.
6. Connect your computer to one of the 10/100 Eth ports on the Wireless Connect Gateway.
Check that the Eth Port Status LED lights.
7. Configure the further parameters via a Web browser.