Nordson 3100V Series Customer Product Manual

A
3-36
lnstallation
To
Program
Setpoint
and
Standby Temperatures lndividually
Follow this
procedure
to
set the setpoint and standby
temperatures
for
each zone.
1. lf
you
have not already
done so, turn
power
on
to the
unit by
pressing
the POWER switch.
2. ln
the System Setup area,
press
the Move
Up and Move Down keys
until the
SETPOINT
or
STANDBY
light
turns on. The system defaults
to the internal zone
type and the INTERNAL light
turns on.
NOTE:
lf
you
have enabled the
password
feature,
you
must change
the
number
in the Multipurpose display
(500)
to the
password
(321)
and
press
the Enter
key before the system will
allow
you
to change
any of
the temperature setpoints.
3. lf
you
want to select
the
hose-zone
type or the
gun-zone
type instead
of the internal-zone
type,
press
the Move Right key until the light
beneath the zone type
you
want
to set turns on.
4.
See
Figure A
3-21
. ln the Displays
area,
press
the
Up
key
(1)
below
the
Selector
display
(2)
until the zone number
you
want
appears on
the display.
(Refer
to Table A
3-7.)
The Multipurpose
display
(3)
changes to show the current
temperature setting for the zone
you
selected.
5.
ln the Displays
area,
press
the Up or Down key
(
)
below
the
Multipurpose
display to change the temperature. The display flashes.
NOTE: Pressing the
Up or
Down
keys in the Displays area once
changes the number shown in increments
of one. Pressing and
holding
the
key
changes the number in increments of five.
A3EN-04-[3V-X-4XXVj-1
3
41-3000v
lssued 5/00
@000 Nordson
Corporation
All rights reseNed

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English