lnstallation
A
3-45
3.
See
Figure A 3-26. Press the
Up
key
below the Selector
display to
select the day code
(1)for
which
you
want
to set a time.
4. Press the Enter key
(4)
to save the day code setting. The Selector
display stops flashing and the hour
(2)
shown in
the
Multipurpose
display flashes.
5. Press the Up or Down keys
(5)
below the Multipurpose display until
the hour for which
you
want
to set a time appears in the display.
6.
Press
the
Enter
key to save the hour setting. The hour shown in the
Multipurpose display stops flashing and
the
minutes flash.
7. Press
the Up or Down keys until the minutes
(3)
for which
you
want to
set a time appear on the Multipurpose display.
L
Press
the
Enter
key to save the minutes setting. All
displays
stop
flashing.
9.
Record
your
setting in the forms
provided
at the end of this section
Refer
to
Records
of
System Settings.
10. To
set a
second
time for the same day,
press
the
Move Right key until
the INTERVAL 2 light
turns on. Press the Enter key to save the day
and repeat steps
5
through
9.
To
Change a Standby or Heater Time
To
change a set time, follow the
procedure
for
setting the standby and
heater times.
@0O0 Nordson Corpotalion
All
rights reserued
41-3000y
lssued 5/00
A3EN-04-[3V-X-4XXVI-1 3