A4-4
Operation
Checking the Adhesive Level
and Filling
the
Tank
Use
this
procedure
to check the adhesive level
and to refill the tank if
necessary.
WARNING: Risk
of
personal
injury. When
the tank lid is
opened, vapors may be released. Vent
the
application area or
wear
a
respirator
for
protection
from vapors.
CAUTION: Risk
of equipment damage. Exposing melted
adhesive
to
air
can accelerate the
curing
process,
causing char.
Refer to
General Hot Melt Material Processing
lnstructions al
the beginning
of this manual for
adhesive material handling
guidelines.
1.
Open the tank lid and check
the adhesive level
2. Refillthe
tank before the adhesive
level drops below
50%. Use a
metal or
plastic
scoop to add
unmelted adhesive to within 25 mm
(1
in.) of the top of
the tank.
25 mm
(1
in.)
50T"
1
2
3
4'130773
Fig.
A 4-2 Filling
the
Tank
1. Refill
level
2. Tank filling
3. Tank-fulllevel
3. Close the lid immediately after filling
I
a
A4EN{6-[3V-A-AAXVJ-1
41
-3000v
lssued
5/00
@00 Nordson Corporation
All rights reserved