Nordson 3100V Series Customer Product Manual

A
3-38
lnstallation
To Program
All
Zones
to the
Same Temperature
Follow
this
procedure
to set all zones
to the same
temperature. Also
use
this
procedure
along with
the
procedure
To Program
Setpoint and
Standby Temperatures lndividually
to set most zones
to the same
temperature.
NOTE:
This
procedure
works only
for zones
that have been
previously
turned on. The default
setting for
all zones is
OFF. To turn
a
zone
on,
refer to
the
previous
procedure,
To Program
Setpoint and
Standby
Temperatures
lndividually,
and set the temperature
of each zone
you
want
to turn on to
at least
38
'C
(100
'F).
1. lf
you
have not
already done
so, turn
power
on to
the unit by
pressing
the POWER switch.
2.
See
Figure
A 3-22. ln the
System
Setup area,
press
the Move
Up
(1)
and Move Down
(2)
keys
until the
SETPOINT or
STANDBY light turns
on. The
system defaults
to the internal-zone
type and
the
INTERNAL
light
turns
on.
NOTE: lf
you
have
enabled
the
password
feature,
you
must
change
the.number in
the Multipurpose
display
(500)
to the
password
(321)
and
press
the
Enter
key before
the system
will allow
you
to
change
any of the
temperature setpoints.
I
lweruBE
-Hr
O
fro**
lSt
r-,
-E-E
EI
J
smrM
1
2
4130305A
Fig. A3-22
Selecting
the Set All Feature
(System
Setup
Area)
'1.
Move
Up key
2. Move Down
key
A3EN-04-[3V-X-4XXVj-1
3
41-3000v
lssued 5/00
@
2000 Nordson Corporalion
All dghts
reserved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English