Nordson 3100V Series Customer Product Manual

B
2-6
Control
Opening
WARNING:
Risk of
equipment damage,
personal
injury or
death. Disconnect
and
lock
out electrical
power
to the unit,
including
inpuVoutput
(l/O)
lines.
1. Place
the unit's
POWER
switch in the off
position,
disconnect and
lock
out electrical
power
to
the unit
at the branch circuit
disconnect
switch, and disconnect
and lock
out electrical
power
supplied through
any l/O wiring.
2.
See
Figure
B 2-3. Loosen
the captive
screws on the
electrical
enclosure
lid, lift
the lid from the unit,
and
prop
it against
the
pump
cover.
Take care not
to disconnect the
ground
wire.
3. Make sure
the support strap is not
wrapped
around any board
components.
Untangle the strap if necessary.
4. Loosen
the two
captive screws on either
side of
the control-end frame
and lower
the frame.
You may need to
pull
the front
and rear covers
apart
to release the frame.
5. Avoid direct
contact with internal
electrical connections,
components,
or wiring.
6. Make
sure all
ground
wires
are securely
connected.
t
t'
41308494
Fig. B 2-3
Opening the Electrical
Enclosure
82
EN-04-[3V-X-4XXyI-s
41-3000v
lssued
5/00
e000 Nordson Coporation
All rights
reserved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English