Nordson 3100V Series Customer Product Manual

22
RTD-Style Hot Melt Hose
lnspecting Hose Hydraulic
Connections
(contd)
t
4110132
Fig. 4 Disconnecting and
Locking
Out
Main Power
WARNING: Air trapped in
the
hoses and
guns
can spit out
molten
adhesive that
can cause severe burns. Shield the area
and the operator before triggering the
guns
to
relieve
hydraulic
pressure.
3. Trigger
all
guns
to
relieve
any trapped
hydraulic
pressure.
4. Disconnect
the solenoids and/or
photoeyes
to
prevent
accidental
triggering
of the
guns.
5. Reduce
air
pressure
to
the
guns:
.
Systems with automatic
guns:
Reduce
gun
air
pressure
to zero at the regulator.
WARNING: Place
handgun trigger
locks in the locked
position
and ALWAYS
hang
the
handgun by
the hole
in its handle.
Failure to do so can result in accidental
gun
firing that can
cause severe burns.
o
Systems
with handguns:
Place the
gun
trigger safety in the locked
position.
Hang the handgun by the hole in its handle.
WARNING:
Even
when switched off,
Nordson
applicators
and
hoses contain electrical
potentials
that can cause death.
Disconnect
and
lock out line voltage to the applicator
when
instructed to do so.
6. See Figure
4.
Disconnect
and
lock out
power
to the main circuit
breaker for
the applicator
input
power
line.
7. lnspect
the hose to applicator and
hose to
gun
fittings for tightness.
NOTE: Always
use
two wrenches to tighten any hose
fittings. Refer
to Table 4 for
the
required wrench sizes.
Manual 45-21
108232E
lssued 1/00
O
2000
Nordson
Corporation
All rights resgrved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English