Daily
Operations
To
do
this.
. . Pressthis
key... This happens... It
means
o
Turn
the
power
on.
Turn the
power
off.
POWER
The POWEFI
switch turns on.
Power
to the unit is on.
The POWER switch turns off. Power to the unit is off
Scan the temperatures
of
each
zone.
Monitor
the temperature
of a zone.
Bblll'on@
c
The MONITOF/SCAN light
turns
on and stays on.
The MONITOR/SCAN light
stays on.
The
system scans each
heated zone and displays
each zone's
temperature.
The
system displays the
temperature of only the
zone currently selected.
Place
the system in
standby.
Take the system
out of
standby.
e"@
The
STANDBY
light turns on
The STANDBY light turns off
Heating zones hold
at
your preset
standby
temperatures.
Heating zones return
to
your
operating setpoint
temperatures.
STANDBY
Turn
the heaters on.
Turn the heaters
off
HEATERS@
c
The HEATERS
light turns on
The HEATERS light turns ofi
The
tank, hoses, and
guns
are
heated.
No heat is
applied to
system
components.
Turn the 7-day
clock on
Turn
the 7-day clock off
CLOCK
o
The
CLOCK light turns on.
The
CLOCK
light turns
otf.
The system
performs
functions controlled by
the
clock.
The
system
does
not
perform
functions
controlled
by the clock.
Turn the
pump
on.
Turn the
pump
off
PUMP
3
0
"E;"
()
The
PUMP light turns on.
The
PUMP light turns off
The
pump
draws melted
materialthrough the
system.
The
pump
stops drawing
melted material
through
the system.
Determine
whether a
fault was corrected.
All LED lights turn on while
the system begins a
five-second test.
.At
the end
of the test, the FAULT light
turns off.
All LED
lights turn on while
the system begins a
five-second test. At the
end
of
the test, the
FAULT light
stays on.
The fault was corrected
The fault was not
corrected.
CLEAR
FAULTS
A
Original copyright date 2197. Nordson
is a registered trademark of Nordson Corporation
6
2297nC
lssued 4/98
To Next Page
Loading...
