Nortech CRC200R - 4.2 Main Installation Parameters; 4.2.1 Date & Time; 4.2.2 Operating Parameter

CRC200R USER GUIDE ISSUE 02
4-2
Press (program) to enter the programming mode. The display will show the first menu item.
Press
to cycle through the menu items. To enter a particular menu item, simply press
(enter) while that item is displayed on the screen. The first parameter of that item will then be
displayed in the bottom row of the screen (unless you move to a sub menu).
To enter or change a parameter, type the new value (or use
to step through options) and press
(enter) to confirm the change. The unit will then move to the next parameter.
On entering the final parameter of a menu item, the unit will automatically move either to the next
menu item or back to the beginning of the current menu item depending upon the particular item.
When you reach the last menu item, a further press of
will take you back to the first menu item
again.
To go back to the opening display, press
repeatedly until it is shown (up to 3 times depending
upon where you are in the menu structure).
The structure of the CRC200R menu system is illustrated in Appendix A.
4.2 Main Installation Parameters
These parameters are set using the “Installer” sub-menu and are used to control the way in which
the controller operates.
4.2.1 Date & Time
Although the time and date settings are factory set, it is advisable to check them briefly before
entering specific installation details.
Press
once and then press repeatedly until the ‘Installer’ screen is displayed, press
once again to enter the sub-menu, and press
repeatedly until “Date/time” is displayed. Press
to show the first parameter. Refer to section 5.5.3 for details of this procedure.
4.2.2 Operating Parameter
For these parameters, you will need to have the following information available:
4.2.2.1 Time Zone Requirements
The CRC200R allows 3 modes of operation:
OFF
(offline)
This mode is no longer used.
LINE
(online)
This mode is used when the CRC200R is to be used as part of a managed network.
The basic features are the same as those for offline operation.
210 This mode offers additional time zone options and card access level features while still
allowing 2 programmable time zones for door open applications. This mode may be
used in either standalone CRC200R or as part of a managed network (Norpass2 must
also have the feature enabled)
Where many time zones and access levels are required Mode 210 must be selected before cards
are added to the system (see sub-section 4.2.2.5 below).