CRC200R USER GUIDE ISSUE 02
5-6
S
e
t P
I N
C
o
d
e
P
i n
2
: x
x
x
x
x
Type in the PIN number for PIN location 2 and press
S
e
t P
I N
C
o
d
e
P
i n
x
: x
x
x
x
x
The screen will continue to increment up to the maximum PIN value
of 9. Press
at any time to escape from this menu item and then
press
to move to the next menu item.
5.5 Installer
This menu item is used to set up installation options. Non-qualified personnel should not alter any
values within this menu item as this may cause the unit to operate incorrectly.
This menu item is selected when
is pressed in ‘Set PIN Code’ and then
is pressed once.
To reach this menu item from the initial display, press
once and then press repeatedly until
the following screen is displayed:
I n
s
t
a
l
l
e
r
This menu item leads to a sub-menu of installation set-up procedures.
Press
to move to the first sub-menu item:
5.5.1 Configure
This sub-menu item allows you to set the main operational parameters of the controller and is
automatically selected when
is pressed in ‘Installer’.
To reach this menu item from the initial display, press
once and then press repeatedly until
the ‘Installer’ screen is displayed, and press
once again. The following screen will be displayed:
C
o
n
f
i
g
Press
and carry out the following procedure:
Display Action
C
o
n
f i g
R
e
l 1
: x
x
x
>
Line Mode: Set the time for relay 1 in tenths of a second up to 25.5
seconds
& then press
.
210 Mode:
Set the time for relay 1 in seconds up to 30 seconds (or
set to ‘0’ for 500ms) & then press
.
To Next Page
Loading...