CRC200R USER GUIDE ISSUE 02
7-1
7 TECHNICAL SPECIFICATIONS
Description: Two channel card reader controller.
Card capacity: Up to 10,000 non-sequential cards on one controller
Suitable readers: Nortech DualProx range, Nortech EM2100 proximity range, RH301
magnetic stripe, RH320 magnetic stripe/keypad combined, ASR603
proximity, MRC310 card capture reader and Hyper X long-range
readers. Any industry standard reader giving Clock & Data or Wiegand
output.
Dimensions: 160mm x 120mm x 30mm.
Weight: 300 grams.
Supply voltage: 12 to 24 volts DC
If the reader voltage link is set to ‘12V’ it connects the supply
voltage directly to the reader. Therefore, if a 12V DC reader is
used then the supply voltage needs to be 12V DC. If in doubt
always measure the reader voltage before connecting the reader.
Please see note in section 3.2.1
Termination:
Pluggable screw terminal strip.
Display: LCD, 2 lines x 16 characters.
Controls: 12 button membrane keypad, 0 - 9, Program, Enter.
Request to exit: 2 independent inputs operating latch relays.
Latches: 2 independent voltage free changeover relays (2A, 30V DC)
Arming: 2 arming inputs (doubled with door monitoring inputs)
Auxiliary Outputs: 2 open collector outputs for card capture, DVC control, etc.
Current requirement: 100 mA quiescent, up to 500mA while reading at both readers
simultaneously (depending upon types of readers).
To Next Page
Loading...