CRC200R USER GUIDE ISSUE 02
5-9
Display Action
S
e
t A
P
B
M
o
d
e
A
P
B
n
o
Use the
key to toggle between ‘’yes’ and ‘no’, then press
.
If
you change the state, the unit will take a moment to initialise all cards
to that state. Also if you select ‘no’, the unit will skip to the next sub-
menu option. If you select ‘yes’ then it will continue as follows:
S
e
t A
P
B
M
o
d
e
A
P
B
H
o
u
r
0
: 2
5
You may then enter an hour in the 24-hour clock (0 to 23). At this
hour every day the Anti-passback will initialise, allowing all cards to
work on all valid readers.
‘0’ = midnight, any number above 23 will disable this ‘APB Hour’.
On pressing
you then have a further three ‘APB Hours’ (1 to 3),
which you can set in the same way.
Note 1: When APB is active, anti-passback initialisation takes place when the CRC200R is
powered up. This process may take several seconds to complete depending upon the
number of cards in the memory.
Pressing
after the last APB hour will take you to the next sub-menu item.
5.5.3 Date/Time
This sub-menu item allows you to adjust the time and date in the unit’s real time clock.
This sub-menu item is automatically selected when the final parameter of ‘APB Mode’ has been
entered.
To reach this sub-menu item from the initial display, press
once and then press repeatedly
until the ‘Installer’ screen is displayed, press
once again to enter the sub-menu, and press
repeatedly until the following screen is displayed:
D
a
t
e
/
T
i
m
e
Press
and carry out the following procedure:
Display Action
D
a
t e
/ T
i m
e
Y
e
a
r
: x
x
Enter the year as two digits and press
.
D
a
t e
/ T
i m
e
M
o
n
t h
: x
x
Enter the month in two-digit format and press
.
D
a
t e
/ T
i m
e
D
a
t e
: x
x
Enter the day of the month as two digits and press
.
To Next Page
Loading...