CRC200R USER GUIDE ISSUE 02
5-7
C
o
n
f i g
D
r
1
h
l d
: x
x
x
>
Enter up to 3 digits to set the timeout for door 1 hold, and then press
.
This is the time (in seconds) that door 1 can be held open for before
an alarm is raised. This facility can only be used in conjunction with
the Norpass2 software.
C
o
n
f i g
D
r
1
T
Z
: x
>
Enter a Time Zone number (0 to 3) and press
. This parameter
controls the times at which door 1 is left unlocked (if any).
0 = never, 1 = always, 2 and 3 = programmable
(See section 4.2.2.4 for a detailed explanation)
C
o
n
f i g
R
e
l 2
: x
x
x
>
Line Mode: Set the time for relay 2 in tenths of a second up to 25.5
seconds
& then press
.
210 Mode:
Set the time for relay 2 in seconds up to 30 seconds (or
set to ‘0’ for 500ms) & then press
.
C
o
n
f i g
D
r
2
h
l d
: x
x
x
>
Enter up to 3 digits to set the timeout for door 2 hold, and then press
.
This is the time (in seconds) that door 2 can be held open for before
an alarm is raised This facility can only be used in conjunction with
the Norpass2 software.
C
o
n
f i g
D
r
2
T
Z
: x
>
Enter a Time Zone number (0 to 3) and press
. This parameter
controls the times at which door 2 is left unlocked (if any).
0 = never, 1 = always, 2 and 3 = programmable
(See section 4.2.2.4 for a detailed explanation)
C
o
n
f i g
O
p
M
o
d
e
O
f f
Press
to step through operation modes:
Off = stand-alone mode (no longer used).
Line = online to control software/memory module (see note 1)
210= extended time zone operating mode (see note 2)
Press
when the desired mode is displayed.
C
o
n
f i g
R
d
r
1
: C
A
R
D
Press
to step through reader 1 door control options:
CARD = normally closed, opens on valid card read
UNLOCKED = permanently open
LOCKED = permanently closed (not effected by valid card read)
Press
when the desired mode is displayed.
C
o
n
f i g
R
d
r
2
: C
A
R
D
Press
to step through reader 2 door control options:
CARD = normally closed, opens on valid card read
UNLOCKED = permanently open
LOCKED = permanently closed (not effected by valid card read)
Press
when the desired mode is displayed.
To Next Page
Loading...