www.linearcorp.com 21 e3 eMerge Installation Instructions
7.4 Configuring the Client and Server on the Network
IP Installer is a utility located on a thumb drive shipped with all systems. e purpose of this
utility is to locate the server and client on the network. It also provides a simple method of
changing the IP address of the controller(s).
Run IP Installer
1. Connect all controllers to the local network.
2. Connect the thumb drive (included with the system) to a Windows computer on the local
network.
3. Locate IP Installer.exe and double-click the le.
4. IP Installer will open. Click Scan to search the network for controllers.
5. When controllers are identi ed they will be listed in IP Installer.
Figure 7.7. IP Installer
Change the IP Address of Server and Client
e default IP address of the server and client is 192.168.0.250. To avoid con ict on the network,
the IP address of the client and server must be changed as follows:
1. Connect the server to the network.
2. Open IPInstaller.exe and click Scan.
3. Select the server from the list and click Set Network.
4. Enter a new IP address for the server. is information must be provided by the IT
Administrator.
5. Change the Subnet Mask and Gateway to meet the requirements of the local network.
6. Enter the IP Installer password (default = 4321) and click OK.
7. Connect the client to the network and repeat steps 1 through 4 to change the client’s IP
address.
IP Addresses of Server and Client
Note: You will have to
change or modify the fi re
wall settings the fi rst time
IP installer is run.
Note: Consult the
appropriate on-site IT
Administrator when
changing the IP Address,
Subnet Mask and
Gateway.
To Next Page
Loading...