EasyManua.ls Logo

Notifier AFP-400 - Supervisory Signal; Non-Alarm Point Operation; Trouble Monitor Point Operation

Notifier AFP-400
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Autoprogram
3URJUDP &KDQJH
AFP-300/AFP-400 Programming PN 50259:C1 06/19/97 7
$XWRSURJUDPPLQJ
'HIDXOWV
Table 8 contains descriptions for the fields that display in the Autoprogram Default
screen for a detector:
Table 8 Autoprogram Default Fields
If a device exists in the control panel program, but is missing (no response from the
program), the control panel displays a screen similar to the following:
)LJXUH  $XWRSURJUDP 'HYLFH 'LVSOD\ 6FUHHQ
To delete the device from memory, press Enter. The next new device appears in the
display.
To keep the device in memory, press <Esc>. The control panel displays the
Program Change screen.
Field Description
SMOKE (PHOTO) Type code of the detector.
DETECTOR ADDR 101 Default custom label: 101 (1=loop 1; 01=address 01).
Z03
1RWH <RX FDQ FKDQJH
]RQHV DV ZHOO DV DGG IRXU
PRUH ]RQHV IRU HDFK
GHWHFWRU·V &%(
Default zone selection:
Zone 01 (Heat detectors)
Zone 02 (Ion detectors)
Zone 03 (Photo detectors)
Zone 04 (Laser detectors)
Zone 05 (Multisensor)
AL:8 (Photo default)
AL:6 (Ion default)
AL:6 (LPX default)
AL:5 (Multisensor
default)
The Alarm sensitivity level, with 9 the least sensitive Alarm level
and 1 the most sensitive Alarm level.
PA:8 (Photo default)
PA:6 (Ion default)
PA:6 (LPX default)
PA:5 (Multisensor
default)
Shows the Pre-Alarm level setting—a number between 0 and 9—
as follows:
0
– no Pre-Alarm.
1
– most sensitive Pre-Alarm level.
9
– least sensitive Pre-Alarm level.
**
*
The first asterisk (*) indicates the cooperative multi-detector
mode:
A combines the detector's alarm decision with the next address
above.
B combines the detector's alarm decision with the next address
below.
C combines the detector's alarm decision with the next address
above and the next address below.
*
– the second asterisk (*) indicates Alarm Verification (V=on,
*=off). Refer to “Interpreting a Detector Status Display or
Maintenance Report” on page 42 for more information on the
Alarm Verification feature.
352*50 602.( ,21 '(7(&725 $''5 
'(9,&( 127 $16:(5,1* '(/(7( )5 0(0 '
7\SH &RGH
7ZRGLJLW DGGUHVV
' GHWHFWRU RU 0 PRGXOH
6/& QXPEHU

Other manuals for Notifier AFP-400

Related product manuals