Novation Xio - Page 64

Cubase SX3 (continued)
In order that the controls on the Xio work correctly with Cubase you need to use the appropriate default
Cubase arrangement supplied on the resources disc. Open the file 'Default_SX.cpr' (or 'Default_SX2.cpr' or
'Default_SX3.cpr' depending on the version of Cubase) to start making music with Cubase and theXioSynth. It
is recommended to copy the default Xio project into the Cubase templates folder so that it is available in the
templates box when you open a new session.
The Cubase templates folder is found in the following location:
PC - Program Files\Steinberg\Cubase\Templates
Mac - Applications\Cubase\Contents\Templates (Control click on the Cubase application and select 'Show
Package Contents' to get to the 'Contents' folder)
FM7
Layout
Group A
Knob 1: Freq Ratio Low
Knob 2: Level
Knobs 3-5: Timbre Bright, Harmonic and Env Amount
Knob 6: LFO Rate
Knobs 7-10: Amp Attack, Decay, Sustain and Release
Knob 11: Effect Strength
Buttons 1 and 2: Operator and Wave
Buttons 3-10: Op Sel, A-F, X and Z On/Off
Button 11: Effect On/Off
Gr
oup B
Knobs 1 and 2: Freq Ratio Mid and LFO Vibrato
Knob 3: Timbre Velocity Sensitivity
Knob 4: Timbre Detune
Knob 5: LFO Timbre
Knob 6: No Control
Knob 7-10: Timbre Attack, Decay, Sustain and Release
Knob 11: Delay Feedback
Buttons 1 and 2: Operator and Wave
Buttons 3-10: O. S, B-F, X and Z On/Off
Button 11: D. T. Sync
Touchpad has Timbre Bright (x-axis) and Timbre Harmonics (y-axis) assigned to it throughout.