FM7 (continued)
Setup
There is an FM7 setup file ‘Xio_LE.F7c’ on the Resources disk, which must be loaded into the FM7.
To load the file into the FM7, click on the controller ‘LOAD’ button in the master section of the FM7.
Navigate to the file ‘Xio_LE.f7c and open it. Note this can then be saved to the c:/program files/native
instruments/FM7/assigns folder where C: is the hard drive that the FM7 is installed on. From the FM7
preferences option, make sure that the following options are checked:
1 MIDI controller range 000-127
2 0...63: off 64...127: on
3 Use OP A controllers for selected op
4 OP Select controller: 9
5 Use 3 ccs for ratio.
Logic 7
Layout
Group A
Knobs 1 and 2: Track Level and Pan
Knobs 3-10: Track 1-8 Sends
Knob 11: Master Vol
Buttons 1 and 2: Track Up and Down
Buttons 3 and 4: Mute and Solo
Buttons 5 and 6: Record Enable and Hide View
Buttons 7-11: Transport (Record, Play, Stop, Rewind, Forward)
Group B
Knobs 1-10: Bus 1-10 Level
Knob 11: Out 1-2 Level
Buttons 1 and 2: Loop and Toggle Drop
Buttons 3 and 4: Mute and Solo
Buttons 5 and 6: Sync and Click On/Off
Buttons 7-11: Transport (Record, Play, Stop, Rewind, Forward)
Touchpad is assigned Aftertouch (x-axis) throughout.
Setup
Locate the files 'com.apple.logic.pro' and 'com.apple.logic.pro.cs' in the folder:
User/Library/Preferences/Logic
To Next Page
Loading...
