NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
29
From the Alert Settings menu, the user can enable/disable alert messages to be sent when the IP Device is not responding and
configure when and how alert messages are sent.
Figure 28- Text Menu-IP Device Alert Settings
Alert Settings Description
Disable alerts Change to “Yes” to prevent alerts from being sent when this IP Device’s status changes
Notify Again Time Enter the amount of time in seconds, minutes, or hours (1-999) before an alert message will be
repeated
Notify on Return to Normal The user can also be notified when the IP Device’s state has returned to the normal by
changing to “Yes” for "Notify on return to normal" for a sensor.
Auto Acknowledge Change to “Yes” to have alert notifications in the summary page return to normal state
automatically when sensor readings return to normal.
Enable Email Alerts Change to “Yes” to have alert notifications sent via Email
Enable Syslog Alerts Change to “Yes” to have alert notifications sent via Syslog messages
Enable SNMP traps Change to “Yes” to have alert notifications sent via SNMP traps (v2c)
Email Subject Enter the subject to be viewed when an email alert message is received
Enable SMS Alerts Change to “Yes” to have alert notifications sent via SMS (requires GSM modem)
Siren Change to “Yes” to activate the siren circuit during an alert condition
Beacon Change to “Yes” to activate the beacon circuit during an alert condition
Press <Tab> to highlight Save and press <Enter> to save before pressing <Esc> to exit.
To Next Page
Loading...
Need help?
General
