NuWave PIC Pro Chef - Programming and Delay Functions

19
Owner’s Manual
OPERATING INSTRUCTIONS (Continued)
Setting Cooking Time
Press “Time”. A “0” will ash in the far-right corner of the display panel. Press “+”
until you reach the desired amount of time.
Examples
To program 5 minutes, press “Time” once, then press “+” until you see “00:05” on
the display. Then press “Start”. For 20 minutes, press “Time” twice, then press “+”
until you see “00:20”, then press “Start”.
For 2 hours and 30 minutes, press “Time” twice before pressing “+” until you
reach 3, then press “Time” again. Press “+” until you reach 2 (the display will show
“02:30”), then press “Start”.
• The blinking “0” indicates the digit you can adjust. The maximum time is
99 hours and 60 minutes.
• The display shows hours and minutes, not seconds.
Programming Function (Stage Cooking)
• Press “Prog”.
• “Pro” will appear in the display panel.
1. Input the desired set temperature, ranging from “Low” to “Max/Sear”. If you
need to increase or decrease the temperature, press “-” or “+”.
2. Press “Time”. “00:00” will appear on the display, then press “-”
or “+” until you reach the desired time. See “Setting Cooking Time” for detailed
information on how to enter minutes and hours.
• To add additional stages, repeat steps 1 and 2 and then press “Start” to begin
your program. You may program up to 10 stages (delay is considered a stage).
• If you need to change any part of the program, press “Pause/Clear” twice to
start over.
Example
In order to boil for 5 minutes before reducing to a simmer for 20 minutes, press
“Prog”, then press “Max/Sear”. Press “Time” once, then press “+” until you reach 5.
Press “Med/Low” next, then press “Time” twice, then “+” until you reach 20. Finally,
press “Start”.
Delay Function
The purpose of this function is to allow for set programs to start at a later time. To
delay a program, press “Prog”, then press “Time”. A “0” will ash in the lower right
corner of the display panel. Press “+” until the desired amount of time you wish to
delay the program start is reached (for more “Setting Cooking Time”). Then press
“Prog” again to set cooking program. The amount of time selected for delay is
included in the programmed stages. To continue to the next stage, enter the
cooking temperature. Continue with step #2 from the “Programming
Function” instructions.
When ready press “Start”. When delay countdown reaches “0”, the NuWave PIC
Pro Chef will beep twice to signal the end. At this point, the cooking time will start
and the temperature will be displayed.