NuWave PIC Pro Chef - Operational Alerts and Beep Codes

22
Owner’s Manual
TROUBLESHOOTING (Continued)
• When any of the error messages display on the LED, the unit will “beep” at
least once.
• The fan will run up to a maximum of 60 seconds after pressing “Pause/
Clear” once. Continue cooking by pressing “Start” within 45 minutes.
• The unit will turn off after 45 minutes if nothing is pressed (such as “Start”).
When the unit shuts off, it will clear all previous cooking history.
• After pressing “Pause/Clear” twice or after cooking has stopped, the fan
will run up to a maximum of 60 seconds until the unit cools. At that point the
NuWave PIC Pro Chef will turn off.
WARNING
Please immediately unplug and contact Customer Service
Department if you experience other problems.
1-877-689-2838 or help@nuwavenow.com
After Removing
Pot
Beep Sound Display Reference
Initial Single beep “F” or “C” or
“Sear” or “:”
Flashing
After returning
the pot, NuWave
PIC Pro Chef
will automatically
resume cooking.
< 45 seconds None “F” or “C” or
“Sear” or “:”
Flashing
After returning
the pot, NuWave
PIC Pro Chef
will automatically
resume cooking.
46 - 90 seconds Yes E1* Resume cooking
by pressing
“Start”.
After 90 seconds None 0 Cooking stops.
*If the PIC Pro Chef is locked and E1 appears:
• Simply unlock by pressing both “Prog” and “Low” and then press “Start” again.
• If you press, “Pause/Clear” twice, you will need to restart the previous program.