Installation and Setup
www.nvidia.com
NVIDIA DGX-1 DU-08033-001 _v13.1|14
2.
Move any other obstructions, such as cable ties, away from the outer edge of the
DGX-1.
3.
With the bezel positioned so that the NVIDIA logo is visible from the front and is on
the left hand side, line up the pins near the corners of the DGX-1 with the holes in
back of the bezel, then gently press the bezel against the DGX-1.
CAUTION: Be careful not to accidentally press the power button that is on the
right edge of the DGX-1 when removing or installing the bezel.
The bezel is held in place magnetically .
2.8.Connecting the Power Cables
1.
Open the accessory box and remove the four C13/C14 power cables.
2.
Use the cables to connect each of the four plugs at the right-rear of the DGX-1 to a
PDU.
To Next Page
Loading...
Need help?
General
