NXP Semiconductors
UM12036
MCX-N9XX-EVK Board User Manual
Figure 10. P1V1 source selection
Once the main power configurations are set, the target MCU power configurations must be made. The MCU
power is configured by a network of jumpers as shown in Figure 11.
These jumpers provide access to insert ammeters in all the supplies connecting to the MCX N94X device. They
also provide a means of connecting external supplies to any of the MCX power pins.
UM12036 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
18 / 51
To Next Page
Loading...
