NXP Semiconductors
UM12036
MCX-N9XX-EVK Board User Manual
Figure 20. FXLS8964AF sensor circuit
2.8 I3C interface
The MCX-N9XX-EVK includes one P3T1755 digital temperature sensor to demonstrate the I3C capabilities of
the target MCU. This device allows for 32 I3C provisional IDs, supports the fully operating voltage of the board
(1.71 V - 3.6 V), programmable overtemperature alerts, 12b resolution, and has an accuracy of ± 1 °C.
Jumper JP23 is used for the I3C Pull-Up Resistance (PUR) provision on the I3C1 SDA signal. For JP23 details,
see Section 1.6
Figure 21 shows the I3C sensor schematic diagram.
Figure 21. I3C sensor schematic diagram
2.9 FlexCAN interface
The controller area network (FlexCAN) is a full implementation of the CAN protocol specification, the CAN with
flexible data rate (CAN FD) protocol, and the CAN 2.0 version B protocol, which supports both standard and
UM12036 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
29 / 51
To Next Page
Loading...
