NXP Semiconductors
UM12036
MCX-N9XX-EVK Board User Manual
1 MCX-N9XX-EVK overview
The NXP MCX N9XX Evaluation Kit (MCX-N9XX-EVK) board is a full-featured evaluation and development
board for application prototyping and demonstration of the MCX N94x family of devices.
The MCX N94X integrates a dual Arm Cortex-M33 MCU and a neural processing unit (NPU) into a single
package. NXP supports MCX N94X with tools and software that include hardware evaluation boards, software
development IDE, example applications, and drivers.
The MCX-N9XX-EVK development board consists of the MCX N94X device with a 64-Mbit external serial flash
(provided by Winbond), FXLS8964AF accelerometer, P3T1755DP I3C temperature sensor, visible light sensor,
onboard CAN PHY, Ethernet PHY, SDHC circuit, general-purpose RGB LED, touch slider, FS and HS USB
circuits, general-purpose push buttons, and onboard MCU-Link debug probe circuit with energy monitoring. The
board is compatible with the Arduino and FRDM ecosystem shield modules and Mikroe click boards.
The onboard MCU-Link debug probe is based on the LPC55S69 MCU. Before using the MCU-Link functionality,
ensure that it is programmed with the required firmware. For details, see Section 3.5.
The board is a standalone PCB and supports application development with the NXP SDK software package.
Note:
•
The MCX N94x represents the MCX N947 and MCX N946 devices in this document.
•
For simplicity, the MCU-Link debug probe is referred to as "MCU-Link" and the MCX N94X MCU is referred to
as "target MCU" in this document.
1.1 Block diagram
Figure 1 shows the MCX-N9XX-EVK block diagram.
Figure 1. MCX-N9XX-EVK block diagram
UM12036 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
2 / 51
To Next Page
Loading...
