NXP Semiconductors MCX-N9 EVK Series - Connectors

NXP Semiconductors
UM12036
MCX-N9XX-EVK Board User Manual
J26
JP43
JP44
JP46
JP41
JP48
J24
JP4
JP28
JP30
JP34
JP39
JP45
JP17
JP21
J17 J18
JP25
JP26
JP29
JP32 JP33
JP40
JP27
JP35
JP31
JP36
JP37
JP47
JP42
JP13
JP15
JP14
JP18
JP16 (DNP)
JP20 (DNP)
JP1 (DNP)
JP3 (DNP)
JP6
JP5
JP9
JP10
(DNP)
JP11
(DNP)
JP12
J23 (DNP)
JP49
JP19
JP38
JP2 (DNP)
JP7 JP8
(DNP)
JP22
JP24
JP23
Figure 4. MCX-N9XX-EVK jumpers
1.5 Connectors
Table 2 describes the MCX-N9XX-EVK connectors. The connectors are shown in Figure 3.
Part
identifier
Connector type Description Reference section
BT1 Coincell battery holder Holder for 3 V CR2025 or CR 2032 lithium
coincell battery required for PMIC Battery
backup (VBAT_BKUP)
Note: This holder is at the bottom of the board
underneath the MCU RST button (SW1).
J24 1 x 2 pin header Lithium-ion/external battery connector
For more information on this
connector, see MCX-N9XX-
EVK schematics
J1 2 x 8 pin header
J2 2 x 10 pin header
J3 2 x 8 pin header
J4 2 x 6 pin header
Arduino compatible I/O header Section 2.12
J5 USB connector MCU-Link USB connector Section 3.7
Table 2. MCX-N9XX-EVK connectors
UM12036 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
6 / 51